Andrew Engineering are very pleased to announce that it has been selected to provide the equipment for the maintenance of the new High Capacity Metro Train Fleet for the Pakenham Maintenance Depot. The equipment supply is: Hegenscheidt Tandem Wheel lathe U2000-400D Bogie Exchange system Bogie Turntables Bogie Rotator Bogie test stand Bogie repair shop Zone […]
Andrew Engineering was contracted to do a complete rebuild and overhaul of the 106TCNC Under Floor Wheel Lathe (UFWL) at the Yarra Trams depot in Preston. The original UFWL was initially installed at Preston in 1994 and has been servicing tram wheel sets for more than 20 years. Working together with Yarra Trams, Andrew Engineering […]
In partnership with Laing O’Rourke, Andrew Engineering delivered and commissioned specialist rolling stock maintenance equipment and depot management systems for the NGRS Maintenance Workshop in Wulkuraka, Queensland. Andrew Engineering was onsite to deliver, install and commission the rail asset maintenance equipment. Andrew Engineering was awarded by Laing O’Rourke as a quality supplier for its “meticulous […]
In partnership with Niles-Simmons-Hegenschedit Group, Andrew Engineering delivered a full turnkey project of the fully automated ore car and wheel and axle repair shop located at Thomas Rail Yard in Port Hedland. This greenfield project was delivered from concept to fully operational within 22 months. Andrew Engineering was onsite to deliver, install and manage all […]
Andrew Engineering was contracted to design, build and install a solution to remove and replace all 12 bogies of a six-car Electric Multiple Unit without the vehicle moving and within a 12-hour cycle. Andrew Engineering designed, built, delivered and installed a first of its kind bogie exchange system (BES). The project was delivered within the […]
Andrew Engineering designed and built a vehicle rotator for the Australian Defence Force’s M113A Armoured Personnel Carrier. This rotator is used to facilitate retrofitting and upgrading of the M113A’s structure. The first vehicle rotator proved to be so successful that a further two were ordered and distributed to other locations in Australia. The Australian Defence […]
Andrew Engineering designed a Robot Leak Test Cell for the Nissan Motor Company Casting Plant. This machine was designed to work in conjunction with the robots to unload trimmed parts from the existing hydraulic trim press and then leak test them using a vacuum. The cell measures the casting with three measuring probes and then […]
